| Specifications: |
|
| Power requirements: |
|
240 VAC three phase, 20A |
| Air supply (required with tail clamp): |
|
80 PSI (minimal CFM) |
| Stock size: |
|
1 to 16 inches wide |
| Coil size: |
|
12 inch standard ID
16 inch optional ID
65 inch maximum OD
16 inch wide, 9000 pound weight capacity |
| Feed rate: |
|
90 FPM with 12 inch mandrel standard
(others available on request)
|
| Mandrel: |
|
Standard 12 inch (expandable 11.5 to 12.5 inches)
Optional 16 inch (expandable 15.5 to 16.5 inches)
|
| Feed direction: |
|
Left to right or Right to left |
| Edge control system: |
|
Analog optical edge sensor with programmable offset,
ball screw actuator driven by a 1/2 HP DC motor and controller,
and linear slides. Automatically adjusts mandrel position
to provide near perfect coil geometry. |
| Spindle motor: |
|
Programmable torque/tension, 5 HP brushless DC drive
0 to 9,750 in-lbs torque at the spindle.
Programmable tension set point at minimum and maximum coil diameter. |
